A 3D printed metallized Fabry–Perot cavity antenna with improved bandwidth and low side‐lobe levels

A 3D printed metallized Fabry–Perot cavity antenna with improved bandwidth and low side‐lobe levels

Blog Article

Abstract A click here 3D printed metallized Fabry–Perot cavity antenna centred at 5.8 GHz is presented in this letter.A non‐uniform grid superstrate and a choke groove are employed in the Fabry–Perot cavity antenna to improve the input bandwidth and decrease the side lobes.

By using the non‐uniform superstrate, the |S11| ← 10 dB bandwidth is enhanced to approximately 6.4% (from 5.65 to 6.

02 GHz).The side lobes decrease to −14.03 and −21.

62 dB on E and H planes by the choke groove.The designed antenna is fabricated by using a stereolithography‐based 3D printing aluminum lotion technique for verification, whose weight is only 13% of the one fabricated with copper.The measured result agrees well with the simulated one.